What are the precautions for the use of pulp pressing equipment?

Precautions for using pulp pressing equipment:

1, before use, you must read this article carefully, so as not to damage the equipment due to improper operation.

2, the amount of mixing slurry in the high-speed mixing tank should not be too little or too much. The total mass of the paste should be controlled between 250 and 450 kg. Under normal circumstances, when mixing cement slurry with cement slurry, 150-250 kg of dry cement can be stirred at a time. According to the actual mixing ratio, water and admixtures can be added. As long as the total amount of paste mixed does not exceed 250 to 350 kg, good measurement accuracy of the equipment can be guaranteed.

3, must ensure the electrical stability of the equipment protection. While taking other effective stability protection measures, users should install their own leakage protection devices.

4, after each shift, all parts of the trolley in contact with the mixing material must be emptied, and the mixing bucket must be cleaned. There shall be no cement or other materials in the conveyor.

5. There are three fixing bolts on the bottom edge of the high-speed mixing barrel. When driving on bumpy roads, it is necessary to use a high speed mixing bucket to lift the high speed mixing bucket from the load cell by 3? 5 mm, and fixed to three posts. This force is not affected by either vertical or lateral forces, so as not to damage the load cell due to violent vibration during transportation. The three retaining bolts should be completely loosened before moving to the destination again. The device has been locked in a shipping state by the manufacturer before leaving the factory. Loosen the bolt completely during use and ensure that the bolt does not touch the fixing point of the nut or the fixing hole of the bolt.

6, the external power supply should ensure that the rotation direction of each rotating system is clockwise.

7, if the equipment is overloaded due to electrical failure, or the lower right corner of the screen alarm prompts the relay pickup error, it should be used after troubleshooting.

8. The Software section includes operations and updates without prior notice. Contact the after-sales service department for technical support.

Disclaimer: This article is editorially reproduced for the purpose of conveying more information only. If you think that our reproduction violates the Copyright Law or damages your interests, please contact us in time, we will deal with it in a timely manner.